 |
The figure on the next left is the configuration of the testbed of the previous dc nanogrid.
The test bad hardware consists of PV pannel, Battery, MPPT Control Module, DC Load, AC Barrel Jack, Voltage Sensor, Ampere Sensor, MCP3008 and Relay.
Power generated from the Pv panel is stored in the battery.
At this time, a voltage sensor and a current sensor were installed between the pv panel and the mppt to measure the amount of power generated, and the sensor was installed between the battery and the mppt in the same manner as above to measure the battery storage.
The amount of power may be calculated using the value measured by the sensor, and the calculated amount of power may be transmitted to the control module of the DC nanogrid.
|
IEEE/ICACT20230159 Slide.08
[Big Slide]